Mountaineer 2WD V8-4.6L (2010)
Electronic Brake Control Module: Service and Repair
Anti-Lock Brake System (ABS) Module
Removal and Installation
NOTICE: Electronic modules are sensitive to electrical charges. The Anti-lock Brake System (ABS) module can be damaged if exposed to these
charges.
NOTE: When installing a new ABS module, it must be configured (using vehicle as-built data) and calibrated. Follow the scan tool directions for the
calibration procedures. For module configuration, refer to Programmable Module Installation in Information Bus.
1. Remove the Hydraulic Control Unit (HCU). For additional information, refer to Hydraulic Control Unit (HCU) See: Antilock Brakes / Traction
Control Systems/Hydraulic Control Assembly - Antilock Brakes/Service and Repair.
2. Remove the 4 screws and the ABS module.
-
To install, tighten to 2 Nm (18 lb-in).
3. NOTICE: Make sure that the Anti-lock Brake System (ABS) module is properly seated to the Hydraulic Control Unit (HCU) and that the
torque of the ABS module screws is correct, or damage to the components can occur.
To install, reverse the removal procedure.
