Mountaineer 2WD V8-4.6L (2010)
Repair/Valve Cover - LH.
7. Remove the nut and position the RH radio interference capacitor aside.
8. Disconnect the RH Camshaft Position (CMP) sensor electrical connector.
9. Remove the nut and the cooling fan wiring harness bracket.
10. Remove the nut and position the LH radio interference capacitor aside.
11. Disconnect the LH CMP sensor electrical connector.
12. Remove the 4 bolts and the coolant pump pulley.
13. Remove the 2 nuts and detach the battery cable bracket from the power steering pump stud bolts.
14. Detach the wiring harness retainer from the power steering pump stud bolt.
15. Remove the 3 stud bolts and position the power steering pump aside.
-
Support the power steering pump with a length of mechanic's wire.
16. Remove the nut and detach the Power Steering Pressure (PSP) hose bracket from the battery cable bracket.
17. Remove the nut and detach the battery cable bracket from the engine front cover.
18. Remove the nut and detach the transmission cooler tube bracket from the engine front cover.
19. Disconnect the Crankshaft Position (CKP) sensor electrical connector.
20. Remove the crankshaft pulley bolt and washer.
-
Discard the crankshaft pulley bolt.
21. Using the 3 Jaw Puller, remove the crankshaft pulley.
22. Using the Crankshaft Front Seal Remover, remove the crankshaft front seal.
-
Discard the crankshaft front seal.
23. Remove the 4 oil pan-to-engine front cover bolts.
24. Remove the 15 engine front cover bolts and stud bolts.
25. Remove the engine front cover from the engine front cover-to-cylinder block dowel.
-
Remove and discard the engine front cover gaskets.
