Mountaineer 2WD V8-4.6L (2010)
Air Door Actuator / Motor: Service and Repair
Temperature Blend Door Actuator - RH, EATC
Temperature Blend Door Actuator - RH, EATC
Removal and Installation
1. Remove the RH floor console finish panel.
2. Lower the glove compartment.
3. Disconnect the RH temperature blend door actuator electrical connector.
4. NOTE: The upper RH temperature blend door actuator screw can be removed using a shallow 1/4-inch drive swivel-type socket and extension.
Working through the glove compartment opening, remove the upper RH temperature blend door actuator screw.
5. Remove the 2 remaining RH temperature blend door actuator screws.
6. Remove the RH temperature blend door actuator.
7. To install, reverse the removal procedure.
