Mountaineer 2WD V8-4.6L (2010)
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove the LH quarter trim panel.
3. Remove the 2 auxiliary line floorpan bracket nuts.
-
To install, tighten to 8 Nm (71 lb-in).
4. Remove the 2 auxiliary heater core and evaporator core housing bolts.
-
To install, tighten to 6 Nm (53 lb-in).
5. Remove the auxiliary heater core and evaporator core housing nut.
-
To install, tighten to 6 Nm (53 lb-in).
6. Disconnect the auxiliary harness electrical connector.
7. Disconnect the auxiliary mode door actuator electrical connector.
8. Remove the 3 auxiliary mode door actuator screws.
9. Remove the auxiliary mode door actuator.
10. To install, reverse the removal procedure.
Vacuum Control Motor - Defroster Door
