Mountaineer 2WD V8-4.6L (2010)
Removal and Installation
1. Remove the RH running board. For additional information, refer to Auxiliary Step / Running Board.
2. Drain the engine coolant. For additional information, refer to Cooling System &/or Engine Block Heater.
3. Remove the RH rear wheel.
4. Release the front auxiliary heater line front clamps and disconnect the heater hoses.
5. Release the front auxiliary heater line rear clamps and disconnect the heater hoses.
6. Remove the 3 auxiliary line bracket nuts.
-
To install, tighten to 6 Nm (53 lb-in).
7. Remove the 3 auxiliary line bracket bolts.
-
To install, tighten to 6 Nm (53 lb-in).
8. Remove the 6 auxiliary line brackets.
9. Remove the front auxiliary heater outlet and inlet lines.
10. To install, reverse the removal procedure.
11. Fill the engine cooling system. For additional information, refer to Cooling System &/or Engine Block Heater.
Auxiliary Heater Outlet and Inlet Line - Rear
Auxiliary Heater Outlet and Inlet Line - Rear
