Mountaineer 2WD V8-4.6L (2010)
Brake Light Switch: Service and Repair
Stoplamp Switch
Removal and Installation
NOTICE: Do not remove or repair the brake pedal, brake booster or master cylinder without first removing the stoplamp switch. Do not
install the stoplamp switch without the brake pedal arm secured to the brake booster push rod. Do not pull or push on the brake pedal when
removing or installing the stoplamp switch, as misadjustment or damage to the switch may occur.
1. Disconnect the stoplamp switch electrical connector.
2. Rotate the stoplamp switch 45 degrees clockwise and remove the stoplamp switch.
3. To install, reverse the removal procedure.
