Mountaineer 2WD V8-4.6L (2010)
Camshaft Position Sensor: Service and Repair
Camshaft Position (CMP) Sensor - 4.6L (3V)
Removal and Installation
RH side
1. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to Fuel Delivery and Air Induction.
Both sides
2. Disconnect the Camshaft Position (CMP) sensor electrical connector.
3. Remove the bolt and the CMP sensor.
-
To install, tighten to 10 Nm (89 lb-in).
4. To install, reverse the removal procedure.
