Mountaineer 2WD V8-4.6L (2010)
12. Disconnect the A/C compressor electrical connector.
13. Remove the A/C compressor electrical connector harness locator.
14. Remove the bolt and position the battery cable right engine mount bracket aside.
-
To install, tighten to 20 Nm (177 lb-in).
15. Remove the starter solenoid terminals protective cap.
16. Remove the nut and position the starter solenoid positive cable terminal aside.
-
To install, tighten to 12 Nm (106 lb-in).
17. Remove the nut and position the starter solenoid wire cable terminal aside.
-
To install, tighten to 6 Nm (53 lb-in).
18. Remove the nut and position the battery cable engine ground terminal aside.
-
To install, tighten to 25 Nm (18 lb-ft).
19. Remove the battery cable.
20. To install, reverse the removal procedure.
