Mountaineer 2WD V8-4.6L (2010)
17. NOTICE: To prevent selector lever cable damage, do not apply force to the selector lever cable between the manual control lever and the
selector lever cable bracket.
NOTE: When installing the selector lever cable end, make sure that the selector lever cable end is correctly installed onto the manual control
lever. Pull back on the selector lever cable end to make sure that the selector lever cable end is securely installed onto the manual control level.
With the manual lever in NEUTRAL, connect the selector lever cable onto the manual control lever and move the locking tab down.
1. Selector lever cable end
2. Locking tab
-
Listen for the audible click.
-
Pull back on the selector lever cable to make sure that it is correctly installed.
18. Install the selector lever cable heat shield.
19. Using the transmission fluid refill procedure, fill and check the transmission fluid. For additional information, refer to Transmission Fluid Drain
and Refill See: Service and Repair/Procedures/6R80/Transmission Fluid Drain and Refill.
