Mountaineer 2WD V8-4.6L SOHC VIN W (2003)
2. Rotate the crankshaft until the cam lobe is directly away from the roller follower.
3. Install the special tool between the valve spring coils to prevent valve stem seal damage.
4. NOTE: The three rear - most followers on the RH side must use special tool 303 - 567 in the same manner as is shown in the illustration.
NOTE: The roller followers and hydraulic lash adjusters are positional. Mark the followers and lash adjusters for installation in their original
locations.
Using the special tool, compress the valve springs and remove the camshaft roller followers.
Item 1: Camshaft Roller Followers Installation Note
1. Rotate the crankshaft until the cam lobe is directly away from the roller followers
