Mountaineer 2WD V8-4.6L SOHC VIN W (2003)
Install the oil pan.
Item 4: Crankshaft Rear Oil Seal Slinger Removal Note
1. Using the special tools, remove the crankshaft rear oil seal slinger.
Item 5: Crankshaft Rear Oil Seal Removal Note
1. Using the special tools, remove the crankshaft rear oil seal.
Item 7: Crankshaft Rear Oil Seal Retainer Plate Installation Note
1. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs, or other abrasive means to clean the sealing surfaces. These tools
cause scratches and gouges which make leak paths. Use a plastic scraping tool to remove all traces of old sealant.
NOTE: If the rear crankshaft seal retaining plate is not secured within four minutes, the sealant must be removed and the sealing area cleaned
with metal surface cleaner. Allow to dry until there is no sign of wetness, or four minutes, whichever is longer. Failure to follow this procedure can
cause future oil leaks.
NOTE: The silicone must be applied on the groove along the retainer plate.
Apply a 4 mm (0.16 inch) bead of silicone gasket and sealant around the rear oil seal retainer plate sealing surface.
Item 6: Crankshaft Rear Oil Seal Retainer Bolts Installation Note
