Mountaineer 2WD V8-4.6L SOHC VIN W (2003)
Part 2 Of 2
2. Install the engine front cover.
3. Tighten the four oil pan bolts in the sequence shown:
^
Stage 1: Tighten to 2 Nm (18 inch lbs.).
^
Stage 2: Tighten to 20 Nm (15 ft. lbs.).
^
Stage 3: Tighten an additional 60 degrees.
Item 2: Power Steering Pressure Hose Installation Note
1. Using the appropriate special tool, install a new O - ring seal on the power steering pressure hose fitting.
Item 1: Power Steering Pump Pulley Installation Note
1. Using the special tool, install the power steering pump pulley.
