mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Technician Safety Information|Page 8154 > < Technician Safety Information|Page 8152
Page 1
background image

Air Bag Resistor: Service and Repair

SAFETY CANOPY BRIDGE RESISTOR

Special Tool(s)

SPECIAL TOOL(S)

REMOVAL

WARNING:

-

Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.

-

Never probe the connectors on the air bag module. Doing so can result in air bag deployment, which can result in personal injury.

NOTE:

-

Restraint system diagnostic tools MUST be installed under the seats in the seat side air bag (if equipped) and safety belt pretensioner (if equipped)
to floor connectors.

-

After diagnosing or repairing an SRS, the restraint system diagnostic tools must be removed before operating the vehicle over the road.

-

The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

-

Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.

1. WARNING:  To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing

or replacing any front or side air bag supplemental restraint system (SRS) components and before servicing, replacing, adjusting or
striking components near the front or side air bag sensors, such as doors, instrument panel, console, door latches, strikers, seats and hood
latches.

The side impact sensors (if equipped) are located at or near the base of the B-pillars and C-pillars.

To deplete the backup power supply energy, disconnect the battery ground cable and wait at least one minute. Be sure to disconnect
auxiliary batteries and power supplies (if equipped).

Disconnect the battery ground cable and wait at least one minute.

2. WARNING:  To reduce the risk of serious personal injury, read and follow all warnings, notes, and instructions in the supplemental

restraint system (SRS) deactivation/reactivation procedure.

Deactivate the supplemental restraint system (SRS).

Technician Safety Information|Page 8154 > < Technician Safety Information|Page 8152