Mountaineer 2WD V8-4.6L SOHC VIN W (2003)
1. For the outboard CV joint, carry out the following:
1
Slide the boot on the interconnecting shaft.
2
Pack the outboard CV joint with 225 grams (7.93 oz.) of grease.
3
Spread any remaining grease evenly inside the boot.
4
Install the boot by seating it in the groove in the CV joint housing.
2. Using the special tool, install the boot clamps.
3. If necessary, install a new brake anti-lock sensor indicator on the outer CV joint.
4. CAUTION: To prevent damage to the axle shaft oil seal, install the Differential Seal Protector before positioning the inboard CV joint housing in
the axle.
CAUTION: Always install the halfshaft with a new retainer circlip and a new rear axle wheel hub retainer.
Install a new retainer circlip.
5. For the inboard CV joint, carry out the following:
1
Position the clamp on the interconnecting shaft.
