Mountaineer 2WD V8-4.6L VIN 8 (2006)
3. Remove the heat shield bolt from the RH heat shield.
-
To install, tighten to 18 Nm (13 lb-ft).
4. Remove the heat shield bolt from the LH heat shield.
-
To install, tighten to 18 Nm (13 lb-ft).
5. Support the transmission with a suitable jack.
6. Remove the 2 transmission mount nuts.
-
To install, tighten to 90 Nm (66 lb-ft).
7. Remove the 6 transmission crossmember lower bolts.
-
To install, tighten to 80 Nm (59 lb-ft).
8. NOTE: Tighten the nut side of the joint.
Remove the 2 nuts and 2 bolts from the transmission crossmember.
-
To install, tighten to 103 Nm (76 lb-ft).
9. Remove the transmission crossmember.
10. To install, reverse the removal procedure.
