mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

ABOUT US
ABS Sensor Block|Service and Repair|Page 7356 > < Turbine Shaft Speed (TSS) Sensor|Page 7350

Mountaineer 2WD V8-4.6L VIN 8 (2006)

  • Brakes and Traction Control
  • Antilock Brakes / Traction Control Systems
  • ABS Sensor Block
  • Component Information
  • Service and Repair

Page 1
background image

ABS Sensor Block: Service and Repair

Stability Control Sensor Cluster 

Stability Control Sensor Cluster

Removal and Installation 

NOTE:  When installing a new stability control sensor cluster, the anti-lock brake system (ABS) module must be configured (using vehicle as-built
data) and calibrated. Follow the diagnostic tool directions for the calibration procedures. For module configuration, refer to Information Bus (Module
Configuration).

1. Disconnect the battery ground cable. 

  • Brakes and Traction Control
  • Antilock Brakes / Traction Control Systems
  • ABS Sensor Block
  • Component Information
  • Service and Repair

ABS Sensor Block|Service and Repair|Page 7356 > < Turbine Shaft Speed (TSS) Sensor|Page 7350