Mountaineer 2WD V8-4.6L VIN 8 (2006)
5. Move the camshaft to the front of the cylinder head. Note and record the camshaft end play.
^
If camshaft end play exceeds specifications, install new camshaft and recheck end play.
^
If camshaft end play exceeds specification after camshaft installation, install a new cylinder head.
Camshaft - Lobe Surface
1. Inspect camshaft lobes for pitting or damage in the contact area. Minor pitting is acceptable outside the contact area.
^
If excessive pitting or damage is present, install new components as necessary.
Camshaft - Lobe Lift
Special Tool(s)
1. Use a Dial Indicator with Bracketry to measure camshaft intake/exhaust lobe lift.
^
Rotate the camshaft and subtract the lowest indicator reading from the highest indicator reading to figure the camshaft lobe lift.
Camshaft - Runout
