Mountaineer 2WD V8-4.6L VIN 8 (2006)
Air Door Actuator / Motor: Service and Repair
Vacuum Control Motor
Air Inlet Door
VACUUM CONTROL MOTOR - AIR INLET DOOR
Removal and Installation
1. Lower the glove compartment.
2. Remove the screws and the heater core and evaporator core housing support brace.
3. Disconnect the air inlet door vacuum control motor vacuum connector.
4. Remove the 2 air inlet door vacuum control motor screws.
5. Rotate the air inlet door vacuum control motor until it clears the retaining arm and remove the vacuum control motor.
6. To install, reverse the removal procedure.
Defroster Door
VACUUM CONTROL MOTOR - DEFROSTER DOOR
