Mountaineer 2WD V8-4.6L VIN 8 (2006)
15. Attach the restraint system diagnostic tool to the vehicle harness side of the passenger seat side air bag module electrical connector.
Vehicles without safety canopy modules
16. CAUTION: Do not deactivate the safety canopy module circuit by removing the safety canopy bridge resistor from the safety canopy
electrical connector.
If the safety canopy bridge resistor is removed, an open circuit fault will be generated by the restraints control module (RCM). If a restraint system
diagnostic tool is installed at the safety canopy electrical connector, a low resistance fault will be generated by the RCM.
Vehicles with safety canopy modules
17. Release and position aside the passenger side C-pillar trim panel.
18. Disconnect the passenger side safety canopy module electrical connector.
