Mountaineer 2WD V8-4.6L VIN 8 (2006)
2. NOTE:
-
Both fuel gauge sending wires must be routed behind the metal sending unit plate.
-
The grounding eyelet must be on the front side of the sending unit.
Hook the fuel gauge sending unit on the fuel pump module and install the screw through the grounding eyelet and tighten the screw.
3. Slide the heat shrink tube onto the wire harness and connect the electrical connector.
4. WARNING: Do not use an open flame to shrink the heat shrink tube, use a heat gun only. Failure to follow these instructions may result
in personal injury.
Using a heat gun, shrink the heat shrink tube.
5. Install the fuel pump.
