Mountaineer 2WD V8-4.6L VIN 8 (2006)
-
To install, tighten to 8 Nm (71 lb-in).
6. Remove the rear suction accumulator-to-compressor line.
-
Discard the O-ring seal.
7. NOTE: The compressor suction fitting nut can be accessed through the RH wheel well.
Remove the compressor suction fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (11 lb-ft).
8. Remove the front suction accumulator-to-compressor line.
9. To install, reverse the removal procedure.
-
Install new O-ring seals and a new gasket seal.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
10. Evacuate, leak test and charge the refrigerant system.
Compressor to Condenser Discharge Line
COMPRESSOR TO CONDENSER DISCHARGE LINE
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.