Mountaineer 2WD V8-4.6L VIN 8 (2006)
Throttle Body: Service and Repair
THROTTLE BODY
Removal and Installation
CAUTION: The throttle body bore and plate area have a special coating and cannot be cleaned.
1. Disconnect the battery ground cable.
2. Remove the air cleaner outlet pipe.
3. Disconnect the electronic throttle control electrical connector.
4. Disconnect the throttle position (TP) sensor electrical connector.
5. Remove the bolts, the throttle body (TB) and the TB gasket. Discard the gasket.
-
To install, tighten to 10 Nm (89 lb-in).
6. To install, reverse the removal procedure.