Mountaineer 2WD V8-4.6L VIN 8 (2006)
3. Detach the rearward lower corner of the watershield on the door to expose the side impact sensor.
4. Disconnect the side impact sensor electrical connector.
5. WARNING: The tightening torque of the side impact sensor retaining bolt is critical for correct system operation.
CAUTION: The ground wire must be placed between the bolt head and the sensor. Never position the ground wire between the U-nut
and the sensor.
NOTE:
-
Make sure the side impact sensor mating surfaces are clean and free of foreign material.
-
Note the position of the side impact sensor locating tabs for installation.
Remove the bolt and the side impact sensor.
-
To install, tighten to 9 Nm (80 lb-in).
6. To install, reverse the removal procedure.
7. Repower the system.
