Mountaineer 2WD V8-4.6L VIN 8 (2006)
Removal and Installation
WARNING: All safety belt assemblies (including retractors, belt tension sensors [BTS] if equipped, buckles, shoulder belt height adjusters [if
equipped], child safety seat tether attachments and attaching hardware) should be inspected after any collision. All new belt assemblies should
be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a
collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these
instructions could increase the risk of injury in collisions.
1. Tilt the seat forward.
2. Remove the 2 screws and inboard side shield.
3. Remove the bolt and safety belt buckle.
-
To install, tighten to 55 Nm (41 lb-ft).
4. To install, reverse the removal procedure.
5. Check the active restraint system for correct operation.
Safety Belt Buckle - Third Row
SAFETY BELT BUCKLE - THIRD ROW
