Mountaineer 2WD V8-4.6L VIN 8 (2006)
retractor assembly must be installed if the safety belt assembly's ALR feature or any other safety belt function is not operating correctly when inspected
according to the functional inspection procedures. Failure to install a new belt and retractor assembly could increase the risk of injury in collisions.
1. Remove the rear quarter trim panel.
2. Remove the bolt and D-ring.
-
To install, tighten to 40 Nm (30 lb-ft).
3. Remove the bolt and safety belt retractor anchor.
-
To install, tighten to 40 Nm (30 lb-ft).
4. Remove the bolt and safety belt retractor.
-
To install, tighten to 40 Nm (30 lb-ft).
5. To install, reverse the removal procedure.
6. Check the active restraint system for correct operation.
