Mountaineer 2WD V8-4.6L VIN 8 (2006)
Brake Switch (Cruise Control): Service and Repair
SPEED CONTROL DEACTIVATOR SWITCH
Removal
CAUTION: Do not press the pedal when removing or installing the speed control deactivator switch, as the switch will be damaged.
1. Disconnect the speed control deactivator switch electrical connector.
2. Rotate counterclockwise 45 degrees and remove the speed control deactivator switch.
Installation
NOTE: When installing the speed control deactivator switch it is automatically self-adjusting to the proper position. Do not pull up or push down on the
pedal during installation. Initial installation of the speed control deactivator switch allows for one adjustment. If additional adjustments are necessary,
install a new switch.
1. Install the speed control deactivator switch, and rotate clockwise 45 degrees.
2. Connect the speed control deactivator switch electrical connector.