Mountaineer 2WD V8-4.6L VIN 8 (2006)
Camshaft Position Sensor: Service and Repair
CAMSHAFT POSITION (CMP) SENSOR
Removal and Installation
Both sides
1. Disconnect the battery ground cable.
RH side
2. Remove the air cleaner outlet pipe.
Both sides
3. Disconnect the camshaft position (CMP) sensor electrical connector.
4. Remove the bolt and the CMP sensor.
-
To install, tighten to 10 Nm (89 lb-in).
5. To install, reverse the removal procedure.
