Mountaineer 2WD V8-4.6L VIN 8 (2006)
Using the special tool, separate the tie-rod end from the wheel knuckle.
5. NOTE: Count the number of turns required to remove the tie-rod end for reference during installation.
Remove the tie-rod end.
6. Remove the tie-rod end Jam nut.
7. NOTE: A new outer bellows boot clamp must be installed.
Remove and discard the outer bellows boot clamp.
8. NOTE: A new inner bellows boot clamp must be installed.
Remove and discard the inner bellows boot clamp.
9. Remove the steering gear bellows boot.
10. CAUTION: Place the steering gear at the center position. Use a 1-1/16 inch crowfoot on the flat of the rack gear to resist rotation and to prevent
damage during removal and installation of the inner tie rod.
NOTE: If repairing the RH side, it will be necessary to pull back the LH inner tie-rod boot to hold the steering gear.
NOTE: An assistant may be needed for removal of the RH inner tie rod.
Using the special tool, remove the inner tie rod.
11. CAUTION: Thoroughly remove any abrasive material. This material is extremely harmful to the steering gear.
Thoroughly clean and inspect all the parts to be reused. Install new parts as necessary.
Installation