Mountaineer 2WD V8-4.6L VIN 8 (2006)
7. With the range selector lever cable end disconnected, unlock the tab on the range selector lever cable end by sliding it up.
8. Carry out the following adjustment on the range selector lever cable end:
1
Make sure that the range selector lever cable end slides forward and backwards.
2
Connect the range selector lever cable end onto the manual control lever.
3
Lock the range selector lever cable end into place by pressing the lock tab down.
9. NOTE: If the shield is loose on the cable, install a new shield.
Install and secure the cable shield.
10. Verify that the engine will start in PARK and NEUTRAL. Verify that the reverse lamps will illuminate in the REVERSE position. If not, check the
adjustment of the transmission range TR sensor.
