Mountaineer 2WD V8-4.6L VIN 8 (2006)
Shift Cable: Adjustments
6R60 Selector Lever Cable Adjustment
Selector Lever Cable Adjustment 6R60
1. With the vehicle in NEUTRAL, position the vehicle on a hoist.
2. Place the range selector in the first position all the way toward the rear of the vehicle.
3. Move the range selector forward 3 detents. This should be the (D) position.
4. Remove the cable shield by prying on the side of the shield closest to the boot, then sliding the shield away from the boot.
5. Disconnect the transmission shift cable from the manual control lever.
6. Rotate the manual lever clockwise until the travel stops. Then rotate the manual lever counterclockwise 3 detents, this should be the (D) position.
7. With the range selector lever cable end disconnected, unlock the tab on the range selector lever cable end by sliding it up.
