Mountaineer 2WD V8-4.6L VIN 8 (2006)
Torque Converter: Testing and Inspection
5R55S Automatic Transmission
Torque Converter Diagnosis
Prior to installing a new torque converter, all diagnostic procedures must be followed. This is to prevent the unnecessary installation of good torque
converters. Only after a complete diagnostic evaluation can the decision be made to install a new or remanufactured torque converter.
Begin with the normal diagnostic procedures as follows:
1. Preliminary Inspection.
2. Know and Understand the Customer Concern.
3. Verify the Concern - Carry out the Torque Converter Clutch Operation Test.
4. Carry out Diagnostic Procedures.
^
Run on-board diagnostics. See On-Board Diagnostics with diagnostic tool.
-
Repair all non-transmission related DTCs first.
-
Repair all transmission DTCs.
-
Rerun on-board diagnostic to verify repair.
^
Carry out the Line Pressure Test. See: Transmission Control Systems/Testing and Inspection/Component Tests and General
Diagnostics/5R55S Automatic Transmission/Non-Trouble Code Procedures/Line Pressure Test
^
Carry out the Stall Speed Test. See: Transmission Control Systems/Testing and Inspection/Component Tests and General Diagnostics/5R55S
Automatic Transmission/Non-Trouble Code Procedures/Stall Speed Test
^
Carry out the Diagnosis by Symptom Index. See: Transmission Control Systems/Testing and Inspection/Symptom Related Diagnostic
Procedures/5R55S Automatic Transmission/Diagnosis By Symptom
-
Use the index to locate the appropriate routine that best describes the symptom(s). The routine will list all possible components that may
cause or contribute to the symptom. Check each component listed, diagnose and service as necessary before servicing the torque converter.
Torque Converter Operation Test
This test verifies that the torque converter clutch control system and the torque converter are operating correctly.
1. Carry out the Quick Test. See On-Board Diagnostics with diagnostic tool. Check for DTCs. Refer to the Diagnostic Trouble Code Charts. See:
Transmission Control Systems/Testing and Inspection/Diagnostic Trouble Code Descriptions/5R55S Automatic Transmission
2. Connect a tachometer to the engine.
3. Bring the engine to normal operating temperature by driving the vehicle at highway speeds for approximately 15 minutes in (D) position.
4. After normal operating temperature is reached, maintain a constant vehicle speed of about 80 km/h (50 mph) and tap brake pedal with the left
foot.
5. The engine rpm should increase when the brake pedal is tapped and decrease about 5 seconds after the pedal is released. If this does not occur,
refer to Torque Converter Operation Concerns in Diagnosis By Symptom. See: Transmission Control Systems/Testing and Inspection/Symptom
Related Diagnostic Procedures/5R55S Automatic Transmission/Diagnosis By Symptom
6. If the vehicle stalls in (D) or MANUAL 2 at idle with vehicle at a stop, move the transmission range selector lever to MANUAL 1 position. If the
vehicle stalls, refer to Diagnosis By Symptom, Torque Converter Operation Concerns. Repair as necessary. If the vehicle does not stall in (D),
refer to Diagnosis By Symptom. See: Transmission Control Systems/Testing and Inspection/Symptom Related Diagnostic Procedures/5R55S
Automatic Transmission/Diagnosis By Symptom
