Mountaineer 2WD V8-4.6L VIN 8 (2006)
Install the solenoids into their correct bores as indicated during disassembly.
4. Install the solenoid bracket and the 8 bolts.
^
Tighten to 8 Nm (71 inch lbs.)
5. Install into the mechatronic assembly the transmission control valves, check balls and filter screens. Refer to the exploded views.
6. Install a new separator plate.
7. Assemble the lower half and the upper half of the mechatronic assembly.
8. Install the 19 short bolts into the mechatronic assembly. Tighten the bolts in the sequence shown.
^
Tighten to 8 Nm (71 inch lbs.).
9. Carefully install the TCM onto the mechatronic assembly.
