Mountaineer 2WD V8-4.6L VIN 8 (2006)
Drive/Propeller Shaft: Service and Repair
Driveshaft - Front
Driveshaft - Front
Material
Material
Removal and Installation
CAUTION: Always disconnect the front driveshaft from the transfer case first. Otherwise, the weight of the driveshaft can pinch the boot between
the driveshaft and the constant velocity (CV) joint flange which can cause the boot to tear.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Index-mark the front driveshaft to maintain driveshaft balance.
3. Remove and discard the 6 CV joint bolts and CV joint washers.
^
To install, tighten to 30 Nm (22 ft. lbs.).
