Mountaineer 2WD V8-4.6L VIN 8 (2006)
Wiper Arm: Service and Repair
Wiper Pivot Arm - Rear
WIPER PIVOT ARM - REAR
Removal
1. Remove the wiper pivot arm cover.
2. Remove the wiper pivot arm.
1
Remove the pivot shaft nut.
2
Remove the wiper pivot arm.
Installation
1. NOTE: Before installation, be sure that the rear window wiper motor is in the PARK position.
Turn the wiper switch ON and OFF to allow the rear window wiper motor to cycle and stop in the PARK position.
2. Position the wiper pivot arm.
3. Install the pivot shaft nut.
-
Tighten to 10 Nm (89 lb-in).