Mountaineer 4WD V6-4.0L VIN E (1999)
^
Remove the adjusting clip from the cable housing. See Figure 3.
^
Cycle the throttle body cam 2-3 times to remove all slack from the speed control cable. Make sure the throttle plate is fully closed with slack
removed from the speed control cable.
^
Back off the cable housing one (1) notch. See Figure 3.
^
Insert the adjusting clip into the cable housing. The speed control cable must not be pulled tight for proper operation.
11.
Install the snow shield on the throttle body if so equipped.
Motorhome
NOTE:
DUE TO MODIFICATIONS MADE BY THE MOTORHOME MANUFACTURERS, THE FOLLOWING SERVICE PROCEDURE IS
GENERAL IN CONTENT.
1.
Position out of the way or remove the engine cover.
2.
Disconnect the fresh air tubes from the clean air tube. Disconnect the clean air tube from the throttle body. See Figure 4.
3.
Remove the snow shield from the throttle body. See Figure 4.
