Mountaineer 4WD V6-4.0L VIN E (1999)
7.
Disconnect the speed control cable from the speed control servo. See Figure 8. Then remove the cable from the vehicle. Pull the cable out through
the wheel well.
8.
Connect a new speed control cable to the speed control servo. Route the cable through the wheel well.
9.
Install the left front inner fender well.
10.
Install the left front wheel/tire assembly. Tighten the lug nuts to 115-142 Nm (85-104 lb-ft).
11.
Lower the vehicle.
12.
Connect the speed control cable to all routing clips.
13.
Connect the speed control cable to the accelerator bracket.
14.
Connect the speed control cable to the throttle body cam.
15.
Adjust the speed control cable, if applicable, as follows:
