Mountaineer 4WD V6-4.0L VIN E (1999)
2
Slide the core wire end out of the speed control servo pulley.
INSTALLATION
1. Insert the speed control cable slug into the speed control servo pulley slot.
1
Gently compress the speed control servo spring.
2
Insert the speed control cable slug into the speed control servo pulley slot.
2. Release the compressed spring while aligning the speed control actuator cable cap tabs with the slots in the speed control servo housing.
WARNING: Incorrect wrapping of the speed control actuator cable around the speed control servo pulley may result in a high idle
condition.
NOTE: Make sure the rubber seal is fully seated onto the speed control actuator cable cap.
3. Rotate the speed control actuator cable cap until the locking arm engages.
