Mountaineer 4WD V6-4.0L VIN E (1999)
B)
If the strand cover is pulled out of the notched cable housing, using either the supplied 4 mm checking gauge or a Vernier caliper, measure
the distance from the inside edge of the mark to the end of the exposed strand cover. Do not include the thickness of the mark when taking
the measurement. See Figures 5 and 6.
^
If the measurement is 4 mm (5/32-inch or 0.157-inch) or greater, no further service is required. Reattach the connector to the throttle body
cam, install the snow/ice shield and release the vehicle.
^ If the measurement is less than 4 mm (5/32-inch or 0.157-inch), the speed control cable must be replaced. For replacement and adjustment
procedures, refer to Section 310-03, Vehicle Speed Control of the appropriate workshop manual.
