Mountaineer 4WD V6-4.0L VIN E (1999)
Spark Plug: Service and Repair
Spark Plug Wire Remover
SPECIAL SERVICE TOOLS
REMOVAL
1. With a twisting motion, use the special tool to pull the ignition wire off of the spark plug.
CAUTION
^
Spark plug wires must be connected properly. Mark the spark plug wires before removing them from the spark plugs.
^
It is important to twist the spark plug wire boots while pulling upward to avoid possible damage to the spark plug wire.
^
Do not use special tool on spark plug wire boots with metal heat shields. Damage to the spark plug wire boots may occur.
2. Remove the LH spark plugs.
NOTE
^
Use compressed air to remove any debris in the spark plug well before removing the spark plugs.
^
If an original spark plug is reused, make sure it is installed in the same cylinder it was taken from. New spark plugs can be used in any
cylinder.
