Mountaineer 4WD V6-4.0L VIN E (1999)
Wheel Fastener: Service and Repair
Rear
Special Tool(s)
Removal
CAUTION: Never use a hammer to remove the wheel stud. Damage to the axle flange, hub flange, wheel bearing, or hub bearing can result.
1. WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension
vehicle. This can be accomplished by turning off the air suspension switch located in the rear jack storage area. Failure to do so can result
in unexpected inflation or deflation of the air shocks, which can result in shifting of the vehicle during these operations.
Turn the air suspension service switch off, if so equipped.
2. Raise the vehicle and install safety stands.
3. Remove the wheel and tire assembly.
4. Remove the rear disc brake caliper, rear disc support bracket and brake disc if so equipped. Support the rear disc brake caliper with safety wire.
5. Using the C-Frame and Clamp Assembly Tool, press the wheel stud from its seat and discard.
Installation
CAUTION: Never use air tools to install wheel studs. The serrations can be stripped from the stud.
