Mountaineer 4WD V6-4.0L VIN E (1999)
Mass Air Flow Sensor: Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
2. Loosen the air cleaner outlet tube clamp at the Mass Air Flow (MAF) sensor and remove the tube.
3. Disconnect the MAF sensor electrical connector.
4. Remove the MAF sensor.
1
Remove the four MAF sensor bolts.
2
Remove the MAF sensor.
CAUTION: The MAF sensor electronics module and body are calibrated as a unit and must be replaced as a unit. Do not tamper with the sensing
elements located in the air flow bypass of the MAF body.
INSTALLATION
