Mountaineer 4WD V6-4.0L VIN E (1999)
Refunds do not apply to this program.
RENTAL CARS
Rental cars are not included in this program.
Attachment II - Labor and Parts Information
LABOR ALLOWANCES
PARTS REQUIREMENTS
DEALER PRICE
For latest prices, refer to:
^
DOES II
^
Updated Price Book
EXCESS STOCK RETURN
Excess stock returned for credit must have been purchased from Ford Customer Service Division in accordance with Policy Procedure Bulletin 4000.
Attachment III - Technical Information
OVERVIEW
This program involves checking the existing PCM calibration (PCM ID) using either Worldwide Diagnostic System (WDS) or New Generation Star
(NGS) Tester. Once you have recorded the PCM ID information, you will need to compare it to the Application/Calibration Chart to see if
reprogramming is necessary. If a later calibration is available other than what is listed in the chart, reprogram the PCM to the latest level.
NOTE:
If you discover that the PCM is already at the latest level, do not attempt to perform the reprogram procedure. No further service is required except to
install an Authorized Modification Label.
SERVICE PROCEDURE
Proceed to the appropriate procedure depending on your choice of diagnostic tools.
^
If using Worldwide Diagnostic System (WDS), use WDS CD-ROM B10 release (or subsequent release if applicable) available via Fordstar, or for
non-Ford star dealers available at:
http://www.fordtechservice.com/vdirs/wds
^
If using Service Bay Technical System (SBTS) and the New Generation Star (NGS) Tester with Rotunda Flash Cable (007-00531) and Rotunda
