Mountaineer 4WD V6-4.0L VIN E (1999)
Flash Card (007-00532), use the October release CD-ROM (or subsequent release if applicable).
RETRIEVING PCM INFORMATION AND REPROGRAMMING USING WORLDWIDE DIAGNOSTIC SYSTEM
1.
Connect the WDS to the vehicle DLC.
2.
Select 16 PIN, then select ALL EXCEPT THOSE BELOW.
3.
Verify the transmission selector is in either PARK or NEUTRAL, set the parking brake and turn the ignition ON.
4.
Select the appropriate model year.
5.
Answer YES or NO when asked if the vehicle is equipped with ABS brakes.
6.
Verify Vehicle Specifications.
7.
Go to LOG VIEWER.
8.
Note the PCM ID information.
9.
Locate the appropriate application in the Application/Calibration Chart and determine if reprogramming is required.
10.
If the PCM requires reprogramming, go to continue with Step 11. If reprogramming is not required, proceed to Preparing Authorized Modification
Label.
11.
To reprogram the PCM, go to the TOOL BOX.
12.
Select MODULE PROGRAMMING.
13.
Select MODULE REPROGRAMMING.
14.
Select PCM.
15.
Answer YES when asked to reprogram.
16.
Proceed to Preparing Authorized Modification Label.
RETRIEVING PCM INFORMATION AND REPROGRAMMING USING THE NEW GENERATION STAR TESTER
1.
Connect the NGS to the vehicle with the applicable diagnostic card inserted.
2.
Turn the key ON and select NEW VEHICLE from the NGS menu. Hit TRIGGER to continue.
3.
Pick the Model Year then hit TRIGGER.
4.
Select the vehicle/engine and hit TRIGGER.
5.
Next, select DIAGNOSTIC DATA LINK from the menu and hit TRIGGER.
6.
Select PCM from the menu and hit TRIGGER.
7.
Select MODULE ID and hit TRIGGER.
8.
Locate the appropriate application in the Application/Calibration Chart and determine if reprogramming is required. If reprogramming is required
go to next step. If not, disconnect the NGS and proceed to Preparing Authorized Modification Label.
9.
To begin the reprogramming process, first download the applicable calibration file onto a Rotunda Flash card (007-00532) and insert into the
NGS.
10.
Connect Rotunda Flash cable (007-00531) to the NGS and to the vehicle.
11.
Select PCM RECALIBRATION from the menu and hit TRIGGER.
12.
Enter the last 8 characters of the VIN and hit ENTER.
13.
Select the applicable calibration file and hit TRIGGER.
