Mountaineer 4WD V6-4.0L VIN E (1999)
1. To install, reverse the removal procedure.
-
Check the restraint system for proper operation.
NOTE: Make sure the seat belt webbing is not twisted prior to installation.
Seat Belt With Anchor Plate Thread Damage
1. Remove the broken or stripped bolt and discard.
2. Drill out the internal threads in the seat belt anchor plate with a 10.7 mm (27/64 in) drill.
3. Rethread the anchor plate with a 1/2-13 tap (seat belt).
4. Clean out the chips.
Typical Parts Replacement Chart
5. Install the attachment parts. Original parts are to be replaced with the repair parts indicated in the Safety Belt Parts Replacement Guidelines.
6. When repairing a multiple belt and attachment, install the nut to the bolt in the tunnel area from the underside of the floorpan.
Shoulder Safety Belt Height Adjuster With Stripped Weld Nuts
1. Remove the B-pillar trim panel.
