Mountaineer 4WD V6-4.0L VIN E (1999)
5. Move the LH front wheel spindle tie-rod into the opening in the crossmember and move the steering gear into position.
6. To place the steering gear in the straight ahead position, turn the steering gear input shaft to the left by half the number of turns recorded
previously.
7. Rotate the steering gear control valve housing toward the rear of the vehicle.
8. Install the steering gear to crossmember insulator bushings as shown.
^
The large end of the metal sleeve must be positioned downward.
^
Check that the mounting surfaces on the crossmember are clean and free of debris.
9. Install the steering gear to crossmember washers and stud bolts.
^
The dished side of the washers face down.
