Mountaineer 4WD V6-4.0L VIN E (1999)
Ride Height Sensor: Service and Repair
Removal
WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing of an air suspension
vehicle. This can be accomplished by turning off the air suspension switch located in the rear jack storage area. Failure to do so may result in
unexpected inflation or deflation of the air springs which may result in shifting of the vehicle during these operations.
1. Raise and support the vehicle.
2. Remove the spare tire.
3. Disconnect the height sensor electrical connector and remove the electrical connector harness from the frame and apron to separate the push-in
fasteners.
4. Release the upper and lower spring clip and pull the sensor from the ball studs.
Installation
1. To install, reverse the removal procedure.
