Mountaineer 4WD V6-4.0L VIN E (1999)
Transmission Mount: Service and Repair
Removal
1. NOTE: 4x2 procedure shown. 4x4 similar, front drive shaft will need to be removed.
Disconnect the battery ground cable.
2. Raise and support the vehicle.
3. NOTE: To maintain initial driveshaft balance, mark the rear driveshaft yoke and axle flange so they may be installed in their original alignment.
Mark the rear driveshaft.
4. Remove the rear driveshaft.
1
Remove the bolts.
2
Remove the rear driveshaft.
5. Remove the transmission mount nuts.
