Mountaineer 4WD V6-4.0L VIN E (1999)
Valve Body: Service and Repair
Removal and Installation
Special Tools
Removal
1. Disconnect the battery ground cable.
2. Raise and support the vehicle.
3. NOTE: Transmission servo heat shield needs to be unclipped from the fluid pan rail and positioned out of the way for fluid pan removal.
Drain transmission fluid.
-
Unclip the servo heat shield and position out of the way.
-
Remove all the transmission fluid pan bolts except for two in the front. Loosen the two transmission fluid pan bolts. Pry the rear of the
transmission fluid pan down and allow fluid to drain. After fluid is drained remove the two remaining transmission fluid pan bolts.