Mountaineer 4WD V6-4.0L VIN E (1999)
10. Install the pinion position shim and the differential pinion bearing.
-
Using the special tool and a suitable press, seat the differential pinion bearing firmly against the pinion position shim.
11. Install a new collapsible spacer.
12. Install the differential pinion bearing and the front axle drive pinion shaft oil slinger.
13. CAUTION: Installing the pinion seal without the correct tool can result in early seal failure.
CAUTION: If the pinion seal becomes cocked during installation, remove it and install a new one.
Using the special tool, install the pinion seal.
14. Lightly lubricate the pinion gear splines.
-
Use Motorcraft SAE 80W90 Thermally Stable 4x4 Axle Lubricant meeting Ford specification WSP-M2C197-A.
