Mountaineer 4WD V6-4.0L VIN E (1999)
Remove both pinch bolts and disconnect the upper ball joints.
-
Pull the RH axle halfshaft, with the wheel knuckle, away from the axle until the axle halfshaft is out of the axle.
-
Pull the LH axle halfshaft, with the wheel knuckle, away from the axle. The LH axle cannot be removed from the axle at this time.
8. Raise the vehicle.
9. Remove the lower engine splash shield, if equipped.
10. WARNING: Tape the U-joint bearing caps to prevent them from falling off the U-joint.
WARNING: Index-mark the front axle pinion flange to the front driveshaft.
Remove and discard the bolts and straps. Secure the driveshaft out of the way.
11. NOTE: Use the Axle Service Plugs Set T95T4850-A to plug the axle openings.
